Sweeping / Vacuum sweeping using a machine
Removing most of the loose dirt from floor coverings using the sweeper or vacuum sweeper. Suitable for smooth to slightly textured floors. The vacuum sweeper will take simultaneously take care of any stirred up dust.
Preparatory work
Select suitable products to match the surface to be cleaned (type / square metres) and the type of soiling.
Block off the area or put up warning signs.
Check, equip and ready the machine and all accessories in compliance with the instructions for use.
Pick up and dispose of very coarse, loose dirt (e.g. strings, bottles, etc.) by hand.
Use a broom to sweep out corners and hard to reach areas.
Note: Switch off the fine dust filter unit of the machine on wet surfaces.
Main task
Use the machine to first sweep / vacuum sweep along the edges (utilising the side brush on the bottom). Then start sweeping / vacuum sweeping the open area in slightly overlapping passes or according to visible signs of dirt (side brush on the top).
Perform a visual check.
Final steps
Reopen the area or remove the warning signs.
Check the fine dust filter and shake off the dust or replace the filter as needed.
Empty the dirt collector.
Dispose of any waste.
Clean the cleaning equipment and replace as needed.
Check the battery, fuel and oil level.
Comments
Wear the personal protective equipment (PPE) required by company regulations, safety data sheets and / or instructions for use.
Always check in advance which product meets your requirements (see Wetrok Cleaning & Care Instructions).
Wetrok AG accepts no liability for damage caused by improper use or incorrect product selection.
